Table of Contents
Advertisement
Watching Channels from an External Device
Switching Each Input Mode can easily switch with the Remote Control
between TV (DTV or Analog TV) and External Devices when they are
connected to the Unit.
1
Turn On a Set-top Box or the Connected Device.
The picture from the Set-top Box or the Connected Device might
●
appear Automatically on the TV screen.
If the picture does not appear
① Press S SOURCE Repeatedly to select the Set-top Box or the
Connected Device and wait a few seconds till the Picture appears.
Pressing H reverses the direction of the Input modes.
●
e.g.)
11.1
Source
DTV / Analog TV
TV
channel
HDMI1
HDMI2
Video
PC
② Use the Remote Control for the Set-top Box or the Connected
Device to select Channels to view.
HDMI1
HDMI2
Video
PC
or
Component
Sleep Timer
Sleep Timer can set the Unit to go into Standby mode after an incremental
period of time.
Press SLEEP Repeatedly to change the amount of time
(increases the time by 30 minutes up to 120 minutes).
Press SLEEP Once to call up the display for checking the remaining time.
To cancel Sleep Timer, press SLEEP Repeatedly until Off is displayed.
●
Switching Audio Mode
Digital TV Operation
1
Press SAP to display the currently selected Language
and the number of available Languages.
2
Press SAP Repeatedly to cycle through the available
Audio Languages.
Note(s)
Available Languages differ depending on the Broadcast.
●
Other is displayed when the Audio Language cannot be acquired or the acquired
●
Languages are other than English, French or Spanish.
Cable / NTSC (Analog) TV Operation
1
Press SAP to display the currently selected Audio mode.
2
While receiving an MTS broadcast, press SAP Repeatedly
to cycle through the available Audio Channels.
e.g.) When All Audio Modes are available
SAP /
STEREO
SAP /
STEREO
: Outputs Stereo Audio
SAP
: Outputs a Second Audio Program
MONO
: Outputs Mono Audio
18
Sleep timer
120 min.
11.1
English
1/3
11
SAP / STEREO
MONO
SAP /
STEREO
Continued on next page.
.
English
Advertisement
Table of Contents
