Siemens TI3.3 Series Instruction Manual page 37

Setting the language
Switch on the appliance with the k
1.
button.
The preset language appears in the
display.
Touch the "V" button cappuccino
2.
repeatedly until the required
language appears on the display.
Touch the "ok" button latte
3.
macchiato to confirm the setting.
The appliance rinses and is ready to
use when "Choose beverage" appears
in the display.
Notes
Language selection only appears
■
automatically when the appliance is
switched on for the first time.
You can change the language at any
■
time. ~ "Settings" on page 42
Before using for the first time en
General information
The factory settings of the fully
automatic coffee machine are
programmed for optimal performance.
The appliance switches off
■
automatically after a specific time.
Whenever a button is pressed, a
■
signal sounds. It can be switched
off.~ "Settings" on page 42
When the appliance is used for the
■
first time, after running a service
programme or has not been
operated for a long period, the first
beverage will not have the full aroma
and should not be consumed.
After commissioning the appliance,
■
you will only achieve a suitably thick
and stable "crema" after the first few
cups have been dispensed.
If the appliance is in use for a long
■
period of time, water droplets will
form on the ventilation slots. This is
normal.
Escaping steam is not a fault but
■
due to the design of the machine.
Before using your new appliance, you
should check and select the water
hardness.~ "Settings" on page 42
37