Table of Contents
Advertisement
INSTALLING THE CAP OVER THE SPEAKER/
MICROPHONE JACKS
Install the cap over the speaker/ microphone jacks when not
using an optional speaker/ microphone or headset.
Note:
◆ To keep the transceiver water resistant, you must cover the
speaker/ microphone jacks with the supplied cap.
1 Place the cap over the jacks so that the locking
2 While holding the cap in place, push it towards
tabs insert into the transceiver grooves.
the bottom of the transceiver until the tabs on
the cap click into place.
•
To remove the cap, hold the top of the cap in
place with your fi nger while inserting a 2 mm or
smaller fl at blade screwdriver under the bottom
of the cap. Slowly slide the screwdriver in until its
tip touches the tab inside the cap, then gently pry
the cap up (handle of screwdriver moving away
from the transceiver) to remove the cap.
5
Advertisement
Table of Contents
