Sewing Buttons - Brother JK2500NT Operation Manual

SEWING BUTTONHOLES AND BUTTONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
If the left side is too open, turn the buttonhole
fine-adjustment screw with a large
screwdriver in the
If the left side is too tight, turn the buttonhole
fine-adjustment screw with a large
screwdriver in the
• This adjustment ensures both sides of the
buttonhole are the same.

Sewing buttons

Stitch
Stitch Length
Pattern
Name [mm
(inch)]
4
Zigzag F
Stitch (1/64)
5
Zigzag F
Stitch (1/64)
6
Zigzag F
Stitch (1/64)
Measure the distance between the
1
buttonholes and set the pattern selection
dial to the Zigzag Stitch (1.5 mm, 3.5 mm
or 5 mm) with the desired width.
Turn off the machine.
2
Change the foot to the button sewing foot
3
"M".
Place the darning plate on the needle
4
plate.
35
"–"
direction.
"+"
direction.
Stitch
Width
Foot Other
[mm
(inch)]
Button
1.5 Sewing Darning
(1/16) Foot Plate
"M"
Button
3.5 Sewing Darning
(1/8) Foot Plate
"M"
Button
5 Sewing Darning
(3/16) Foot Plate
"M"
Turn on the machine.
5
CAUTION
●
Do not turn on the machine while
pressing down the foot controller. The
machine may start unexpectedly and
cause personal injury or damage to the
machine.
Put a button between the foot and the
6
fabric and make sure that the needle enters
the holes without hitting the button. If it
hits, see step .
1
At a slow speed, sew about 10 stitches.
7
CAUTION
●
Make sure the needle does not hit the
button during sewing. The needle may
break and you may be injured.
Pull the upper thread at the end of the
8
stitching to the wrong side of the fabric,
and then tie it with the bobbin thread.
Use scissors to cut the upper thread and
the bobbin thread at the beginning of the
stitching.