New Holland D180C Tier 4 Service Manual page 31

Product Color
7380 Yellow
to light
amber
7471 Yellow
to light
amber
7649 Green
Prod- Color Strength
uct
603 Green 13.5 - 22.5 MPa
(1958 -
3264 psi)
609 10.3 - 15.8 MPa
Green
(1494 -
2292 psi)
620 Green 17.2 - 24.1 MPa
(2495 -
3496 psi)
635 Green 13.8 - 31.0 MPa
opaque (2002 -
4497 psi)
Surface Preparation
Active (Steel/Steel)
Time
6 hours Is designed to initiate the cure of Loctite toughened acrylic
adhesives.
30 to 70 seconds Is used where increased cure speed of LOCTITE® anaerobic
products is required. It is especially recommended for applications
with passive metals or inert surfaces and with large bond gaps. Is
particularly recommended when prevailing temperature is low <
15 °C (60 °F).
30 to 70 seconds Is used where increased cure speed of LOCTITE® anaerobic
products is required. It is especially recommended for applications
with passive metals or inert surfaces and with large bond gaps. Is
particularly recommended when prevailing temperature is low <
15 °C (60 °F).
Retain, Cylindrical Assemblies
Fixture/Full
Cure (Steel/
Steel) Time
7 min/6 hrs
25 min/6 hrs
1 hr 10 min/18
hrs
30 min/72 hrs
INTRODUCTION
Recom-
mended
Primer or
Activator
7471 or Is designed for the bonding of cylindrical fitting
7469 parts, particularly where consistently clean surfaces
cannot be assured. The product cures when
confined in the absence of air between close fitting
metal surfaces and prevents loosening and leakage
from shock and vibration. Typical applications
include retaining roller bearings or oil impregnated
bushings into housings.
7471 or
Is designed for the bonding of cylindrical fitting
7469 parts. The product cures when confined in the
absence of air between close fitting metal surfaces
and prevents loosening and leakage from shock
and vibration. Typical applications include rotor to
shafts in fractional and subfractional horsepower
motors. Locks bushings and sleeves in housings
on shafts. Augments press fits.
7471 or Is designed for the bonding of cylindrical fitting
7469 parts. The product cures when confined in the
absence of air between close fitting metal surfaces
and prevents loosening and leakage from shock
and vibration. Typical applications include locating
pins in radiator assemblies, sleeves into pump
housings and bearings in auto transmissions.
Particularly suitable for applications where
temperature resistance up to 200 °C (395 °F) is
required.
7471 or Is designed for the bonding of cylindrical fitting
7469 parts. The product cures when confined in the
absence of air between close fitting metal surfaces
and prevents loosening and leakage from shock
and vibration. Typical applications include rotor to
shafts in fractional and subfractional horsepower
motors. Locks bushings and sleeves in housings
on shafts. Augments press fits.
47645621 31/05/2014
26
Description
Description