U-Line ULNSS1095FC03A Quick Start Manual page 15

QUICK START GUIDE
QUICK START GUIDE
Install top hinge and door:
1. Use alternate hinge supplied with unit and reinstall the
screws. Do not tighten..
2. Rotate door 180° to reverse and set the door onto the
bottom hinge.
3. Align flat edge of the hinge with the outer edge of the
unit.
4. Tighten three screws.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT).
Install grille
Door Latch
MARINE MODELS
The door latch assembly included with your unit can be
installed to prevent the door from opening when the
vehicle is in motion.
To install, perform the following:
1. Remove the two outer most screws from the non-hinge
side.
2. Place spacer (2) over mounting holes. Place latch (1)
on top of spacer (2). NOTE: Spacer (2) only required if
included with unit.
3. Re-install the screws, but do not tighten all the way.
4. Verify door latch engagement and adjust as necessary.
5. Tighten screws.
2
Door latch can be used to prop door open approximately
1/2" (13 mm) when unit is not in use.
12
12
u-line.com
u-line.com
1