Table of Contents
Advertisement
Removing the CD changer unit
Prior to performing the following procedure, remove
the metal cover.
1.
Disconnect the card wire which is attached with
adhesive to the left side of the CD changer unit.
2.
Disconnect the card wire from connector CW105 of
the CD servo board on the back of the CD changer
unit.
3.
Disconnect the harness from connector RCW6 on
the inner side of the main board in the body.
Remove the two screws C attaching the CD changer
4.
unit on the back of the body.
Remove the two screws D attaching the CD changer
5.
unit on the both side of the body.
Draw the CD changer unit upward from behind while
6.
pulling the rear panel outward.
CD changer unit
Rear panel
Fig.10 b
(See Fig.8 to 10)
Adhesive card wire strap
D
Front panel assembly
CD servo board
CW105
Main board
Rear panel
CD changer unit
D
Fig.10 a
MX-K5/MX-K6
CD changer unit
RCW6
Fig.8
C
Fig.9
Rear panel
Advertisement
Table of Contents
