Manual Operation (Cool, Dry, Fan) - Mitsubishi Electric MS-18RV Operating Instructions Manual

MANUAL OPERATION (COOL, DRY, FAN)

To select the COOL, DRY or FAN mode
1
2
To stop operation:
I
˚C
CLOCK
AMPM
AMPM
TOO TOO
ON/OFF
WARM COOL
I
FAN STOP
I FEEL COOL
VANE START
FAN DRY
MODE HR.
I
ECONO COOL MIN.
RESET CLOCK
When the ambient temperature is too high, the room tem-
perature may not reach the set temperature since the unit
operates to cool under high load.
ON/OFF
Press the button.
Select the operation mode by pressing the
MODE
button.
Each time this button is pressed, the operation mode
(I FEEL...) → → → → →
is changed in sequence:
→ → → → → (DRY) → → → → →
(FAN)
ON/OFF
Press the button.
After the operation mode is set once, the operation
starts in the mode set previously from the next time
ON/OFF
by simply pressing the button.
When the set temperature is to be changed:
TOO
WARM
I Press the
button to lower the temperature. One
°
press lowers the temperature by about 1 C.
TOO
COOL
I Press the
button to raise the temperature. One
°
press raises the temperature by about 1 C.
In DRY operation
I The temperature control (temperature setting) can-
not be done.
I The room temperature is slightly lowered in this op-
eration mode.
The details of the display on the indoor unit are
explained on page 8.
NOTE
CONVENIENT INFORMATION
COOL
For effective cooling
1 Close the windows and pull
down blinds. Sunshine is re-
duced and cooling efficiency
increases.
(COOL)
DRY The humidity at which people feel comfortable
When air contains too much moisture, people feel clammy. Humidity is related to temperature and wind. The
humidity at which people feel comfortable is 60% - 75% RH in summer, 55% - 70% RH in winter.
2 Paste a heat shield film (gen- 3 Block the outdoor unit from di-
erally available) on the window. rect sunlight. This saves en-
Heat entering the room is re- ergy.
duced.
9