Asus REPUBLIC OF GAMERS SWIFT PG248Q User Manual page 20

•. Max.Refresh.Rate: allows you to select a preferred maximum refresh rate
(Only for DisplayPort input). After selecting your preferred refresh rate,
press the
After reboot, test the new Max Refresh Rate by enabling it in the NVIDIA
Control Panel. If you don't see an image, disconnect the DP cable and use the
monitor OSD to try again with a safer Max Refresh Rate.
2.. Blue.Light.Filter
In this function, you can adjust the blue light filter level.
Over Clocking
Blue Light Filter
Color
Image
Input Select
System Setup
•. Level.0:.No change.
•. Level.1~4: The higher the level, the less blue light is scattered.
When Blue Light Filter is activated,the default settings of Racing Mode
will be automatically imported. Between Level 1 to Level 3, the Brightness
function is user-configurable. Level 4 is optimized setting. It is compliance
with TUV Low Blue Light Certification. The Brightness function is not user-
configurable.
3.. Color
You can adjust Brightness, Contrast, Saturation, Color temperature and
Gamma from this menu.
Over Clocking
Blue Light Filter
Color
Image
Input Select
System Setup
3-2
( ) button twice to activate the setting.
Level 0
Level 1
Level 2
Level 3
Level 4
MOVE/ENTER
Brightness
Contrast
Saturation
Color Temp.
Gamma
MOVE/ENTER
Normal Mode HDMI 1920 x 1080@ 60Hz
ASUS ROG PG248Q
BACK
EXIT
Normal Mode HDMI 1920 x 1080@ 60Hz
ASUS ROG PG248Q
80
50
BACK
EXIT
Chapter 3: General Instructions
Racing Mode
Racing Mode