Philips SRP6013 User Manual page 7

5
If the light is off, a valid code is saved.
Otherwise, the light will flash once, and
then remains on for code re-entry.
6
Operate the device with the universal
remote. If your device responds correctly,
it means you have entered the right code.
Otherwise, repeat from step 2, and enter
the second code on the list.
Note
•
It is possible sometimes that your device only responds
to some of the buttons. In such case, set up with the
next code in the code list, and try operating your
device again.
•
Each device button can be used to set up any device.
E.g. you may setup a TV using the BD device button.
Auto registration
1
Switch on your device.
2
Press and hold the device selection button
(e.g. TV) for 5 seconds until the red LED
is on.
3
Point at your device with the universal
remote. Then press and release
start searching the code for your brand.
A different infrared signal is sent every 2
seconds as the universal remote searches,
indicated by a red flash.
to
EN
5