Table of Contents
Advertisement
6
SAFETY INSTRUCTIONS
y Please follow the installation
y
instructions below to
prevent the product from
overheating.
- The distance between the
y
product and the wall should
be more than 10 cm.
- Do not install the product in
y
a place with no ventilation
(e.g., on a bookshelf or in
a cupboard).
- Do not install the product
y
on a carpet or cushion.
- Make sure the air vent is
y
not blocked by a tablecloth
or curtain.
Otherwise, this may result in
fire.
y Take care not to touch the
y
ventilation openings when
watching the TV for long
periods as the ventilation
openings may become hot.
This does not affect the
operation or performance of
the product.
y Periodically examine the cord of your appliance,
y
and if its appearance indicates damage or
deterioration, unplug it, discontinue use of the
appliance, and have the cord replaced with
an exact replacement part by an authorized
servicer.
y Prevent dust collecting on
y
the power plug pins or outlet.
This may cause a fire
hazard.
y Protect the power cord from
y
physical or mechanical
abuse, such as being
twisted, kinked, pinched,
closed in a door, or walked
upon. Pay particular
attention to plugs, wall
outlets, and the point where
the cord exits the appliance.
y Do not press strongly upon
y
the panel with a hand or
sharp object such as nail,
pencil or pen, or make a
scratch on it.
y Avoid touching the screen
y
or holding your finger(s)
against it for long periods of
time. Doing so may produce
some temporary distortion
effects on the screen.
y When cleaning the product
y
and its components, unplug
the power first and wipe it
with a soft cloth. Applying
excessive force may cause
scratches or discolouration.
Do not spray with water or
wipe with a wet cloth. Never
use glass cleaner, car or
industrial shiner, abrasives
or wax, benzene, alcohol
etc., which can damage the
product and its panel.
Otherwise, this may result in
fire, electric shock or product
damage (deformation,
corrosion or breakage).
y If this unit is connected to the AC power point
y
it should be powered down to standby before
disconnecting from AC power point source or
switch off from power point.
y When unplugging the cable,
y
grab the plug and unplug it,
by pulling at the plug.
Don't pull at the cord to
unplug the power cord from
the power board.
As this could be hazards.
y When moving the product,
y
make sure you turn the
power off first. Then, unplug
the power cables, antenna
cables and all connecting
cables.
The TV set or power cord
may be damaged, which
may create a fire hazard or
cause electric shock.
y When moving or unpacking
y
the product, work in pairs
because the product is
heavy.
Otherwise, this may result in
injury.
Advertisement
Table of Contents
