Leveling And Door Alignment - LG LS74SDT Owner's Manual

20 INSTALLATION
9
Connect tubing to the refrigerator.
NOTE
• Before making the connection to the refrigerator, be
sure that the refrigerator power cord is not plugged
into the wall outlet.
• Remove the plastic flexible cap from the water valve.
• Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
•
Insert the end of the copper tubing into the connection
as far as possible. While holding the tubing, tighten the
fitting.
Tubing
Clamp
1/4 in. Compression Nut
Ferrule
(sleeve)
10
Turn the water on at the shutoff valve.
Tighten any connections that leak.
Caution
• Check to see if leak occur at the water line
connection.
1/4 in. Tubing
Refrigerator
connection

Leveling and Door Alignment

Leveling
The refrigerator has two front leveling legs. Adjust the
legs to alter the tilt front-to-back or side-to-side.
If the refrigerator seems unsteady, or the doors do
not close easily, adjust the refrigerator's tilt using the
instruction below:
1
Turn the leveling leg to the left to raise that side of
the refrigerator or to the rigth to lower it. It may take
several turns of the leveling leg to adjust the tilt of
the refrigerator.
NOTE
• A flare nut wrench work best, but an open-end
wrench will suffice. Do not over-tighten.
• Parts, functionsm and option vary by model. Your
model may not include all the Options, appears
with a different name and / or different position.
2
Open both doors and check to make sure that
they close easily. If the doors do not close easily
tilt the refrigerator slightly more to the rear by
turning both leveling legs to the left. It may take
several more turns, and be shure to turn both
leveling legs the same amount.