Specifications - Makita M1100 Instruction Manual

ENGLISH
1. Pointer
2. Cutting depth indication
3. Knob
4. Lock button / Lock-off button
5. Switch trigger
6. Socket wrench
7. Bolts
8. Drum
9. Planer blade
10. Drum plate
11. Adjusting plate
12. Inside edge of gauge plate
13. Blade edge
14. Screw(s)
15. Heel

SPECIFICATIONS

Planing width
Planing depth
Shiplapping depth
No load speed (min
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
..... Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for planing wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Explanation of general view
16. Back side of gauge base
17. Gauge plate
18. Gauge base
19. Planer blade locating lugs
20. Heel of adjusting plate
21. Set plate
22. Inside flank of gauge plate
23. Mini planer blade
24. Groove of drum
25. Makita vacuum cleaner
26. Standard (non-round) chip cover
27. Start
28. End
29. Handle
30. Cutting line
Model
-1
)
Net weight
Safety class
END201-5
General Power Tool Safety
Warnings
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
ENE001-1
instructions for future reference.
The term "power tool" in the warnings refers to your
ENF002-2 mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
31. Edge fence
32. Align the "V" groove with the edge
of the workpiece.
33. Sharpening holder
34. Wing nut
35. Blade (A)
36. Blade (B)
37. Side (D)
38. Side (C)
39. Limit mark
40. Chip cover
41. Screwdriver
42. Brush holder cap
M1100
82 mm
3 mm
20 mm
18,000
390 mm
4.6 kg
/II
GEA005-3
5