Table of Contents
Advertisement
en Troubleshooting
Fault
Programme starts automat-
ically.
Appliance stops during the
programme or cuts out.
All LEDs lit up or flashing.
Mechanical damage
Fault
Appliance door cannot be
closed.
58
Cause
You did not wait until pro-
gramme ended.
Appliance door is not closed
properly.
Power and/or water supply
has been interrupted.
Top basket is pressing
against inner door and pre-
venting appliance door from
being closed securely.
Electronics have detected a
fault.
Cause
Door lock has been activ-
ated.
Door cannot be closed due
to installation method.
Troubleshooting
→ "Terminate programme",
▶
Page 35
Close the appliance door.
▶
Check the power supply.
1.
Check the water supply.
2.
Check whether the rear panel of the
▶
appliance is being pressed in by a
socket or hose holder that has not
been removed.
Arrange the tableware so that no
▶
parts project beyond the basket
and prevent the appliance door
from closing properly.
Press the main switch button for ap-
1.
prox. 4 seconds.
→ "Controls", Page 16
The appliance is reset and restar-
ted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or
‒
switch off the fuse in the fuse
box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse
‒
box or insert the mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service",
Page 61
Troubleshooting
Close the appliance door with
▶
greater force.
Check whether the appliance has
▶
been installed properly.
Advertisement
Table of Contents
