Electrical Power; Operating The Air Compressor; Assembly - California Air Tools 210DLV Owner's Manual

electrical power

electrical power requirements
DANGER
There is a danger of electric shock.
Use only undamaged electrical cords.
DO NOT touch bare wires or receptacles.
DO NOT operate air compressor in wet weather or in
wet conditions.
DO NOT touch air compressor or cords if hands or
feet are wet.
Ensure that all cords are free of damage before
connecting to the power supply.
Ensure that you have a sufficient electrical supply for
supporting the requirements of the motor.
before using the air compressor, refer to the serial label for
voltage and amperage requirements. Make sure you have a
sufficient electrical supply for supporting the motor's
requirements.
use a dedicated circuit for the best results.
Low voltage and/or an overload circuit can cause the motor's
overload protection system circuit breaker to trip.
electrical extension cords
CAUTION
Use caution when using extension cords.
Use an extension cord which is no more than
25 feet long and at least 14 gauge.
Using an excessively long or thin-wired extension
cord will cause severe damage to the motor.
Use only a 3-wire extension cord that has a 3-blade
grounding plug.
Inspect all electrical extension cords to ensure that they are
free of damage.
When using an extension cord, use a heavy-duty cord that is
no more than 25 feet long and at least 14 gauge.
use only a 3-wire extension cord that has a 3-blade grounding
plug.
SHOCK
Customer Support: 1-866-409-4581
AIR COMPRESSOR
OPeRATING THe AIR
COMPReSSOR

assembly

CAuTION: do not attempt to operate this air compressor
without first adding oil to the crankcase. Serious damage will
result from even limited operation unless filled with oil and
broken in correctly. Make sure to closely follow initial start-up
procedures. Compressor oil is provided; on a level surface,
please fill the crankcase to proper level indicated on the sight
glass.
WARNING: Compressors are shipped without oil. a small
amount of oil may be present in the pump upon receipt of the air
compressor. This is due to factory testing and does not mean the
pump contains oil.
CAuTION: Multi-Viscosity motor oils, like 10W 30, should not
be used in an air compressor. They leave carbon deposits on
critical components, thus reducing performance and compressor
life. use air compressor oil only.
1. Place Air Compressor on level surface. Remove Oil
shipping plug from the crankcase.Add Oil until the oil level
rises to the center of the red dot on the Oil Sight Glass.
Install Oil breather Cap into oil hole.
2. Attach the air filter to the top right side of motor head.Screw
air filter into the motor head. dO NOT over tighten.
3. Attach the wheel by sliding the bolt #55 through the wheel #54.
Slide the washer #56 onto the end of the bolt #55. Slide the end
of the bolt #55 through the wheel support hole on the compressor.
Attach the washer #57 and nut #58 onto the bolt #55 and tighten.
Repeat assemble for other wheel.
Attach the cushion foot #51 by sliding the bolt #53 through the
washer #52 and cushion foot #51onto the support. Attach the
washer #50, spring washer #49 and tighten with the nut #48.
9