Chamberlain NDIS User Manual

Overview
The Wireless Doorbell and Intercom can determine who is at the door from anywhere in the house. The doorbell and intercom have up
to a 1000 foot (300 m) range and use a 900 MHz secure digital radio link. The intercom is compatible with various Chamberlain Wireless
Products.
Carton Inventory
Rubber Pads
Features
INTERCOM
Channel
Channel Select
Lights
Button
Monitor
Button
AC Adapter
Learn Button
On/Off: To turn intercom ON, press Talk button. To turn
intercom OFF, hold down the Volume DOWN button for 3
seconds.
Talk Button: Following the ringing
of the doorbell by a guest, press
and hold the Talk button to talk
to the guest. Once the link to
the doorbell is made, any other
intercoms in the network cannot
hear the conversation.
Volume: Pressing the Volume DOWN button will lower the
volume and pressing the Volume UP button will increase the
volume.
Battery: The AA Alkaline batteries
(not provided) will last up to a year
depending on use. When batteries
are low intercom will emit three
beeps every ten minutes.
A DC Adapter (not provided)
can also be used to power the
intercom. In this case, the channel
lights will remain on.
HOLD
OFF
VOLUME
MONITOR
ACTIVE
TALK
CHANNEL
1 3
2 4
Intercom
Talk
Button
Active Light
Speaker
Volume DOWN
Button
Volume UP
Button
Dipswitch #1
Dipswitch #2
OPTIONAL
®
WIRELESS DOORBELL AND INTERCOM
Mounting Tape
Alcohol Wipe
Doorbell
Voice Activation Mode (VOX):
Voice Activation Mode (VOX)
allows a call to be answered
without pressing the Talk button.
Once a call is heard on an intercom
which has been set to VOX, a response can be given by
speaking loudly into the intercom. There will be a slight delay
when VOX is first activated by a voice, but will continue to
transmit audio until the speaking stops. To put intercom into
VOX, place Dipswitch #1 to the UP position. While in VOX
mode, a call may be initiated by pressing the Talk button.
DOORBELL
Call Button: To talk, press and release the Call button and all
intercoms in the network will receive the signal. When holding
down the Talk button on a different intercom, a secure channel
is created and the other intercoms in the network do not hear
the conversation. Once a secure link is made, the Call button
on the doorbell does not need to be pressed to speak again.
Battery: The AA Alkaline batteries (not provided) will last up to
a year depending on use. (Lithium batteries recommended for
colder environments.)
Alternate Chimes: The doorbell
can be set to ring with two different
chime patterns, to identify which
doorbell is signaling. To change
chime pattern, set Dipswitch #2 to
the UP position.
Volume: To increase the doorbell
volume, set Dipswitch #4 to the UP
position.
Sensitivity: To increase sensitivity
on the doorbell set Dipswitch #3 to
the UP position.
1
Models NDIS and NDISC
2
1