Table of Contents
Advertisement
Adjusting the Viewfinder
Adjusting the Mounting Height of the Viewfinder
The mounting height of the viewfinder will differ depending on the camera on which it is
mounted.
Adjust the mounting height to match the camera on which the viewfinder is to be
mounted.
Camera model number
NTSC regions
PAL regions
AJ-D810, AJ-D810A,
AJ-D900W, AJ-D900WA,
AJ-D900W, AJ-D900WA,
AJ-D910WA
AJ-D910WA,
AJ-PD900W, AJ-PD900WA
NTSC regions
PAL regions
AJ-D700, AJ-D700A
AJ-D700, AJ-D700A,
AJ-D800, AJ-D800A
NTSC regions
PAL regions
AQ-23W
AQ-23W
For camera models other than those listed above, please refer to the camera's instruction manual.
OAdjusting the height of the mounting unit
1.
Detach the two screws, the detach the
mounting unit.
2.
Replace the three screws in the positions indicated as A or B from the present
positions and change the position of the metal fitting.
Metal fitting
Re-fix the metal fitting by fastening the screws together with the spring washer.
3.
Secure the mounting unit in place with the two
screws.
Mounting position
Factory setting
No adjustment of the mounting
height is necessary.
Change to position A
Change to position B
Mounting unit
Screws
Screws
E– 7
Adjusting the Viewfinder
Mounting the Viewfinder
1.
Confirm that the POWER switch of the camera is "OFF".
2.
Insert the plug into the connection jack of the viewfinder.
<Note>
Be sure to insert the plug all the way into the connection jack.
3.
Push the viewfinder down into place.
4.
Tighten the stopper screw firmly.
Detaching the Viewfinder
1.
Confirm that the POWER switch of the camera is "OFF".
2.
Loosen the stopper screw and detach the viewfinder by pulling it straight up.
<Note>
Use both hands to detach the viewfinder. The viewfinder may not detach smoothly
with one hand, resulting in damage to the viewfinder.
3.
Disconnect the connection jack from the viewfinder cable connector.
Stopper screw
Stopper screw
E– 8
Advertisement
Table of Contents
