1. Manuals
  2. Brands
  3. Boss Audio Systems Manuals
  4. Car Receiver
  5. CD-3190R
  6. User manual

Boss Audio Systems CD-3190R User Manual

In-dash cd receiver
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual

Advertisement

Table of Contents
loading

Related Manuals for Boss Audio Systems CD-3190R

Summary of Contents for Boss Audio Systems CD-3190R

  • Page 2 1. BUTTONS LOCATION AND FUNCTIONING PANEL LOCAL/DX POWER BUTTON RELEASE BUTTON BUTTON (ILL) ENCODER AUDIO VOLUME BUTTON BUTTON BUTTON MONO/ DISPLAY STEREO BUTTON BUTTON AUTOMATICALLY SOURCE SCAN STORE / PRESET BUTTON / BUTTON SCAN BUTTON SUB-WOOFER PRESET EQUALIZER (LOC) BUTTON MUTE PRESET MEMORY BUTTONS (M1~M6) REMOTE...

  • Page 3: Handling Compact Discs

    2. HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated.

  • Page 4: Installation

    3. INSTALLATION Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

  • Page 5: Din Rear-Mount (Method B)

    Removing the unit Trim Plate Installation: Push the trim plate against the chassis until it is fitted. You must do this before you install the front panel, otherwise it can't be attached. DIN REAR-MOUNT (METHOD B) Installation using the screw holes on the sides of the unit. Fastening the unit to the factory radio mounting bracket.

  • Page 6: Detachable Control Panel (D.c.p .)

    4. DETACHABLE CONTROL PANEL (D.C.P .) Removing The Detachable Control Panel (D.C.P .). PANEL RELEASE BUTTON Attaching the DCP CAUTION DO NOT insert the D.C.P from the left side. Doing so may damage it. The D.C.P can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks.
  • Page 7 5. WIRING DIAGRAM (20 PIN HARNESS PLUG) FUSE 20-PIN AUDIO/POWER HARNESS (See Figure 1) DIN SOCKET 8 PIN CD CHANGER (OPTION) LEFT FRONT WHITE-BLACK LF- WHITE LF+ LEFT REAR GREEN-BLACK LR GREEN LR+ WIRE COLOR FUNCTION/LABEL RIGHT FRONT SPEAKER (-) GREY/BLACK RIGHT FRONT SPEAKER (+) GREY...
  • Page 8 6.PANEL OPEN/CLOSE OPERATION (MOTORIZED SLIDE DOWN VERSION) This unit is equipped with the most advanced full logic motorized slide down system. You can enjoy this advance technology with just a single press of the “OPEN” button Please read the following instructions carefully before operating the unit.

  • Page 9: Basic Operations

    7. BASIC OPERATIONS 1) PANEL RELEASE BUTTON (REL) Press this button to remove the control panel. 12)POWER ON/OFF BUTTON Press this button long to turn on or off the power. In VFD button short press this button to toggle dimmer function. This will change the brightness of VFD and there are three levels of brightness can be selected.

  • Page 10: Audio Operations

    8. AUDIO OPERATIONS 10)ENCODER VOLUME BUTTON To increase the volume, rotate the volume control clockwise. T o decrease the volume, rotate the volume control counter clockwise. When volume is adjusted, the volume level will be shown on the display panel as a number ranging from 0 (lowest) to 46 (highest). 5) AUDIO BUTTON Press this button to select desired audio function.

  • Page 11: Radio Operations

    9. RADIO OPERATIONS 11) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1.PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. 2.AUTO MEMORY STORE: Press AS/PS button for couple of seconds to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories.
  • Page 12 Press this button to pause CD play, press again to release pause. Press this button, the first 10 seconds of each track will be played sequentially until this button is pressed again, then normal play will resume at the current track. Press this button, the current track will be played repeatedly until this button is pressed again.

  • Page 13: Cd Changer Operations

    11.CD CHANGER OPERATIONS The CD Changer must be properly installed before operation, connect the CD Changer control cable to the CD Changer control input socket at the back of the unit. CD PLAYING Press the Mode Button to select CD mode, if CDs are loaded and the magazine is inserted, the LCD will display "CDC"...

  • Page 14: Remote Control

    12.REMOTE CONTROL OPERATIONS: Radio Mode 1. Power Power On/Off 2. Volume Up/Down Adjust Vol,Bas, Tre,Fad,Bal Display Clock, Spectrum 3. DISP 4. Stereo/Mono FM Mono/ Stereo 5. Track Up/Down Tuning/Seek Up/Down 6. Loc Local /Distant 7. Scan Station Scan 8. Mute Mute Select Vol, Bas, 9.

  • Page 15: Specifications

    13.SPECIFICATIONS CD PLAYER System Usable disc Sampling frequency No of quantization bits Frequency Number of channels S/N Ratio RADIO SECTION Frequency Range Intermediate Frequency Usable Sensitivity Stereo Separation S/N Ratio AM/MW Frequency Range Intermediate Frequency Usable Sensitivity S/N Ratio GENERAL Power Supply Polarity Speaker impedance...

  • Page 16: Troubleshooting

    14.TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom No power The car ignition is not on. The fuse is blown. Disc cannot be loaded Presence of CD disc inside or ejected...

Table of Contents