Raymarine E32158 Installation Instructions Manual page 55

• Dimensions
• Type
• GPS antenna position
The manner in which configuration is carried out depends on the
legal requirements of the geographical area you are.
Important: Before starting any AIS configuration procedure,
SWITCH OFF all associated multifunction displays, otherwise you
will not be able to correctly configure your AIS transceiver.
USA
In the USA, it is a legal requirement that the configuration is
performed by a suitable dealer.
You can use the supplied proAIS2 PC software, to check the vessel
data programmed into your AIS transceiver. If this information is
incorrect please contact your Raymarine dealer before using the
transceiver.
Areas outside of USA
In areas outside of the USA, use the supplied proAIS2 PC software
to configure your AIS transceiver, as described in the proAIS2 User
Manual which can be found in the proAIS2 applications help menu.
Checking for interference
Post installation check
If you have installed any system aboard a boat or made other
changes to the boat's electronic systems (radar, VHF radio etc.),
you need to check before casting off, that all electrical systems
operate satisfactorily without any undue electrical interference,
in order to conform with Electro Magnetic Compatibility (EMC)
regulations. To do this:
1. Ensuring it is safe to do so, turn on all electronic systems aboard
your vessel.
AIS650 Class B transceiver
2. Check that the electronic systems all operate satisfactorily.
Using AIS
The exact method of using AIS depends on which type of Raymarine
multifunction display you are using.
Refer to the handbook for your multifunction display for information
on using your AIS.
55