Package Contents; How To Set Up Jumper; Cpu Installation - Biostar P4TSV Description

Package contents

HDD Cable X 2
FDD Cable X1
User's Manual X1
Fully Setup Driver CD X1
StudioFun! Application CD X 1 (optional)
USB 2.0 Cable X1 (optional)
S/PDIF Cable X 1 (optional)
Rear I/O Panel for Micro ATX Case X1 (optional)
Serial ATA Cable X1
Serial ATA Power Switch Cable X1

How to set up Jumper

The illustration shows to how set up jumper. When the Jumper cap is placed on pins, the
jumper is "close". IF no jumper cap is placed on the pins, the jumper is "open". The
illustration shows a 3-pin jumper whose pin1and 2 are "close" when jumper cap is placed
on these 2 pins.
Jumper open

CPU Installation

Step1 Step1: : : : Pull the lever sideways away from the socket and then raise the lever up to a
Step1 Step1
90-degree angle.
Step2 Step2 Step2: : : : Look for the white dot/cut edge. The white dot/cut edge should point wards the Step2
lever pivot. The CPU will fit only in the correct orientation.
Step3: Step3: Hold the CPU down firmly, and then close the lever to complete the installation.
Step3: Step3:
Step4: Put the CPU Fan on the CPU and buckle it. Connect the CPU fan power cable to Step4:
Step4: Step4:
the JCFAN1. This completes the installation.
Jumper close
5
Pin1-2 close