Configuring Snapshot Recording Settings - Lorex N842A82 User Manual

17 Using the Main Menu
2. Click CAMERA. Click the Overlay tab on the side panel, then click the Privacy Masking
tab on the top panel.
3. Under Channel, select the camera you would like to configure.
4. Check Preview or Record. Preview means the privacy mask zone(s) cannot be viewed when
the system is in preview status. Record means the privacy mask zone(s) cannot be viewed
when the system is in recording status.
5. Select 1 to 4 privacy masking zones on each channel. To set the size of the zone(s) click and
drag the outer white line around the box.
6. Click Apply to save changes.
7. (Optional) Click Copy to copy privacy masking settings to other channels.

17.4.6 Configuring Snapshot Recording Settings

The system can be set to record snapshot images when a camera detects motion. These snapshots
can be viewed through the Playback menu or can be attached to email alerts and push notifica-
tions. Use the following procedure to set the snapshot parameters for each camera.
NOTE
Snapshot recording must be enabled for motion detection in the Event menu. See 12 Motion Detection, page
37for details.
To configure snapshot recording settings:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click CAMERA, then click theRecording tab on the side panel. Click the Snapshot tab on
the top panel.
#LX400113; r. 9.0/57192/57197; en-US 64