Table of Contents
Advertisement
Installation
Standalone Installation
Setting up the Video Splitter is simply a matter of plugging in the
cables. Refer to the diagram as you follow the step by step
directions below:
1. Make sure that the computer and monitors you are using for
the installation are all powered Off.
2. Plug the female end of a male to female VGA cable into the
Video Splitter's Video In port; plug the male end of the cable
into the computer's video output port.
Note: The VGA cable does not come with the package. It must
be purchased separately: (Part No. 2L-2401).
3. Plug the monitor cables into any available Video Out port.
4. Plug the power adapter (supplied with this package) into an
AC source; plug the adapter's power cable into the Video
Splitter's AC 9V Power Jack.
5. Power On all equipment.
- 9 -
Advertisement
Table of Contents
