Using The Cd-Rom Drive - Asus T9A User Manual

Inserting a CD
1. While the Notebook PC's power is ON, press
the CD drive eject button and the CD drive
tray will eject out partially.
3. Hold the CD by the edge and face the printed
side up. Snap the CD onto the hub by press-
ing on both sides of the CD center. The hub
should be higher than the CD when cor-
rectly mounted.
NOTE: It is normal to hear as well as feel the CD spinning with great intensity in the
CD drive while data is read.

Using the CD-ROM Drive

CD-ROM discs and equipment must be handled with care because of the precise mechanics involved.
Keep in mind the important safety instructions from your CD suppliers. Unlike desktop CD-ROM
drives, the Notebook PC uses a hub to hold the CD in place regardless of the angle. When inserting a
CD, it is important that the CD be pressed onto the center hub or else the CD-ROM drive tray will
scratch the CD.
WARNING! If the CD disc is not properly locked onto the center hub, the CD can be
damaged when the tray is closed. Always watch the CD closely while closing the tray
slowly to prevent damage.
Using the Notebook PC
2. Hold the CD drive front panel and slide the CD
drive tray completely out. Be careful not to touch
the CD drive lens and other mechanisms. Make
sure there are no obstructions that may get jammed
under the CD drive tray.
4. Slowly push the CD drive tray back into the Note-
book PC. The drive begins reading the table of
contents (TOC) on the CD. When the drive stops,
the CD is ready to use.
4
41