Handling For Wireless Remote Controller - Daikin BRC7CB58 Operation Manual

NOTES
• For the sake of explanation, all indications are
shown on the display in Fig. 1 contrary to actual
running situations.
• Fig. 1-2 shows the remote controller with the
front cover opened.
• If the AIR FILTER CLEANING TIME INDICATOR
LAMP lights up, clean the air filter as explained
in the operation manual attached to the indoor
unit.
After cleaning and reinstalling the air filter, press
the FILTER SIGN RESET BUTTON on the
remote controller. The AIR FILTER CLEANING
TIME INDICATOR LAMP on the receiver will go
out.
• The DEFROST OPERATION LAMP will flash
when the power is turned on. This is not a mal-
function.
• Do not place the remote controller where subject
to direct sunlight. The display of the remote con-
troller will get discolored and may fail to display
information.
[CAUTIONS]
Make sure to turn off the unit and disconnect
the power supply breaker when taking care
of the air conditioner.
Unless the power supply is disconnected, it
may cause electric shocks and injuries.
4. HANDLING FOR WIRELESS
REMOTE CONTROLLER
[Precautions in handling remote controller]
Direct the transmitting part of the remote con-
troller to the receiving part of the air conditioner.
If something blocks the transmitting and receiving
path of the indoor unit and the remote controller as
curtains, it will not operate.
2 short beeps from
the receiver indicates
that the transmission
is properly done.
Transmitting distance is approximately 7 m.
Do not drop or get it wet.
It may be damaged.
5
Receiver
Never press the button of the remote controller
with a hard, pointed object.
The remote controller may be damaged.
Installation site
• It is possible that signals will not be received in
rooms that have electronic fluorescent lighting.
Please consult with your local dealer before buy-
ing new fluorescent lights.
• If the remote controller operated some other elec-
trical apparatus, move that machine away or con-
sult your local dealer.
Placing the remote controller in the remote con-
troller holder.
Install the remote controller holder to a wall or a pil-
lar with the attached screw.
Placing the remote
controller
Slide from above
Remote
controller
holder
How to put the dry batteries
(1) Remove the back cover of the
remote controller to the direc-
tion pointed by the arrow mark.
(2) Put the batteries
Use two dry cell batteries
(AAA.LR03 (alkaline)). Put dry
batteries correctly to fit their (+)
and (–).
(3) Close the cover
When to change batteries
Under normal use, batteries last about a year. How-
ever, change them whenever the indoor unit doesn't
respond or responds slowly to commands, or if the
display becomes dark.
Removing the
remote controller
Pull it upward
English