Asus PRIME H310M-DASH Manual page 11

M.2 socket 3
This socket allow you to install an M.2 (NGFF) SSD module.
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data
of the system setup information such as date, time, and
system passwords.
To erase the RTC RAM:
1.
2.
3.
4.
Intel
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The
chassis intrusion sensor or switch sends a high-level signal to this connector when
a chassis component is removed or replaced. The signal is then generated as a
chassis intrusion event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
Speaker connector (4-pin SPEAKER)
The 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
ASUS PRIME H310M-DASH
E14287_PRIME_H310M-DASH_UM.indb 3
This M.2 socket supports M Key and 2242/2260/2280 storage
devices.
Turn OFF the computer and unplug the power cord.
Use a metal object such as a screwdriver to short the
two pins.
Plug the power cord and turn ON the computer.
Hold down the <Del> key during the boot process and
enter BIOS setup to re-enter data.
If the steps above do not help, remove the onboard battery and short the two pins again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
H310 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
®
M.2(SOCKET3)
CLRTC
PIN 1
1-3
7/2/2018 2:04:10 PM