Table of Contents
Advertisement
w w WARNING
Personal Injury Hazard
Avoid contact with the moving parts of the
ejector mechanism, or with the heating
element that releases the cubes. DO NOT
place fingers or hands on the automatic
icemaking mechanism while the refrigerator is
plugged in.
OPERATION INSTRUCTIONS
A newly-installed refrigerator may take
12 to 24 hours to begin making ice.
lcemaker
Water Amount
Water Amount
Indicator Lights
Selection
Button
The icemaker will produce six cubes per cycle—
approximately 100–130 cubes in a 24- hour period,
depending on freezer compartment temperature,
room temperature, number of door openings and
other operating conditions.
If the refrigerator is used before the water
connection is made to the icemaker, set the power
switch to O (off).
When the refrigerator has been connected to the
water supply, set the power switch to I (on).
The icemaker will fill with water when it cools to
freezing. A newly-installed refrigerator may take 12
to 24 hours to begin making ice cubes.
Throw away the first few batches of ice to allow the
water line to clear.
Be sure nothing interferes with the sweep of the
Automatic Shut off Arm.
When the bin fills to the level of the Automatic Shut
off Arm, the icemaker will stop producing ice.
It is normal for several cubes to be stuck together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale, and shrink.
ABOUT THE AUTOMATIC ICEMAKER
Automatic
Shutoff Arm
ON/OFF
Switch
NOTE: If the cube size is smaller or larger than
you expected, you can regulate the size with the
cube size button.
Every time you press the cube size button, the
indicator moves up on light. The higher the light
position, the larger the cubes will be. Pressing at
highest position returns indicator to lowest
position.
WHEN YOU SHOULD SET THE
ICEMAKER POWER SWITCH TO
O (OFF)
• When the water supply will be shut off for
several hours.
• When the ice bucket is removed for more than a
minute or two.
• When the refrigerator will not be used for
several days.
NORMAL SOUNDS YOU MAY HEAR
• The icemaker water valve will buzz as the
icemaker fills with water. If the power switch is
in the I (on) position, it will buzz even if it has
not yet been hooked up to water. To stop the
buzzing, move the power switch to O (off).
NOTE: Keeping the power switch in the I (on)
position before the water line is connected can
damage the icemaker.
• You will hear the sound of cubes dropping into
the bin and water running in the pipes as the
icemaker refills.
PREPARING FOR VACATION
Set the icemaker power switch to O (off) and
shut off the water supply to the refrigerator.
If the ambient temperature will drop below
freezing, have a qualified servicer drain the water
supply system to prevent serious property
damage due to flooding from ruptured water lines
or connections.
35
Advertisement
Table of Contents
