Rheem EcoSense ECOH200DV Series Use And Care Manual page 60

INSTALLATION INSTRUCTIONS
Electrical Wiring
Connecting the Remote Control to the Water
Heater:
1
Ensure that the power to the water heater has
been disconnected.
Remote Control Remote Control
Connection Cover Connection Cover
2
Loosen the one screw located on the remote
control connection cover. The connection cover
is made of white plastic.
NOTICE:
PANEL. Remote control wires are connected on
the bottom of the unit.
There are no accessible remote control
terminals inside the water heater.
3
Connect the remote control extension cables
from the remote control to the remote control
connection terminals.
NOTICE:
connection terminals are not polarity-sensitive.
60
(cont.)
DO NOT REMOVE FRONT
The remote control wire
4
Firmly tighten the terminal screws by hand.
5
Secure the remote control extension cable on
the hook located on the side of the remote
control connection base.
6
Reinstall the remote control connection cover
and secure with the one screw.
NOTICE:
Do not connect power until
venting installation is complete.
7
Switch on the power supply to the water heater.
Check for proper operation of the remote
control and the water heater.