Table of Contents
Advertisement
Setup
a : Master Drive (Choose the MA Jumper)
c : MainBoard
e : Secondly 1
If there is two Optical drive, select MA (Master) / SL (Slave).
a : Master Drive (Choose the MA Jumper) b : Slave Drive (Choose the SL Jumper)
c : Hard Drive
e : Primary 1
Installing a jumper on the master/slave select terminal
Connect a jumper to the rear side of the COMBO.
If the jumper is connected to MA (Master), it will work in the Master mode.
If the jumper is connected to SL (Slave), it will work in the Slave mode.
If the jumper is connected to CS (CSEL), you can control the device by using the host interface signal
CSEL. (In general, connection to MA is recommended.)
b : Hard Drive
d : Primary 1
d : MainBoard
f : Secondly 1
Hide quick links:
Advertisement
Table of Contents
