Table of Contents
Advertisement
Registering Magic Remote
Control
How to register the Magic
Remote Control
To use the Magic Remote, first pair it with your
TV.
1 Put batteries into the Magic Remote and turn
the TV on.
2 Point the Magic Remote at your TV and press
Wheel (OK) on the remote control.
the
* If the TV fails to register the Magic Remote, try
again after turning the TV off and back on.
How to deregister the Magic
Remote Control
Press the
/
and
the same time, for five seconds, to unpair the
Magic Remote with your TV.
* Press and hold the
more than 5 seconds to disconnect and re-
register the Magic Remote at the same time.
(HOME) buttons at
/
button for
• Do not mix new batteries with old
batteries. This may cause the batteries
to overheat and leak.
• Failure to match the correct polarities
of the battery may cause the battery to
burst or leak, resulting in fire, personal
injury, or ambient pollution.
• This apparatus uses batteries. In
your community there might be
regulations that require you to dispose
of these batteries properly due to
environmental considerations. Please
contact your local authorities for
disposal or recycling information.
• Batteries inside or inside the product
shall not be exposed to excessive heat
such as sunshine, fire or the like.
User Guide
For more information about this TV, read the
USER GUIDE embedded in the product.
• To open the USER GUIDE
[Support] → [User Guide]
→
→
17
Advertisement
Table of Contents
