Network Connection - Wired - Samsung UN40D5550RF User Manual

Network Connection - Wired

There are two main ways to connect your TV to your network using cable, depending on your network setup. They are
illustrated below:
The Modem Port on the Wall
The LAN Port on the Wall
Configuring the Network Connection - Wired
Most home networks use the Dynamic Host Configuration Protocol (DHCP) to configure network connections. Home networks
that support DHCP automatically provide the IP address, subnet mask, gateway, and DNS values your TV needs to access the
Internet so you don't have to enter them manually.
To configure your network connection for a network that uses DHCP, follow these steps:
1. Connect your TV to your network as shown in one of the
illustrations above.
2. Turn on your TV, press the
then select Network → Network Settings. The Network
Settings screen will appear.
3. Select Wired, press ENTERE, and then press ENTERE
again.
4. The Network Connection screen appears, and verifies the
network connection. When the connection has been verified,
the "Internet connection successful." message appears.
Network set up is completed.
✎
If your TV cannot acquire network the connection values
automatically or if you want to set the connection manually, select IP Settings on the network test screen. Set Internet
Protocol Setup to Manual. You must enter the IP Address, Subnet Mask, Gateway, and DNS Server manually.
✎
For more detailed information, see "Wired Network Connection" in the e-Manual.
Extternal Modem
(ADSL / VDSL / Cable TV)
Modem Cable
LAN Cable
MENU button on your remote, and
English - 16
TV Rear Panel
LAN Cable
TV Rear Panel
Network Settings
Select a network connection type.
Wired
Wireless(General)
Connect to the network using LAN
cable. Please make sure that the
WPS(PBC)
LAN cable is connected.
One Foot Connection
Previous
Next
Cancel