Table of Contents
Advertisement
ADA compliance
If a height of 32 1/4'' is required for ADA compliance, remove the upper
trim kit. Also lower the trim kit on the sides.
Placing the dishwasher
The dishwasher is intended to be built in under a countertop. The
built-in measurements are shown in the illustration. Make sure that the
cord and hose hole's edges are even and will not damage the drain
and inlet hoses or the power cord.
The electrical and
water supplies should
enter through the area
indicated by the
shading on the
illustration.
*32 1/4'':
Remove the trim kit.
NOTE!
Framed cabinets require additional finished filler material behind the
face frame for a proper installation. A minimum 3½" (89 mm) finished
return is required on all sides of the opening.
Frameless
cabinetry
If the dishwasher is built-in, the surrounding furnishings must be
resistant to any condensation from the dishwasher.
Fit the protective film
Fit the protective film (packed in the document bag) to the underside
of the countertop. The protective film is to protect the countertop from
moisture.
NOTE!
The surface to which the protective film is fitted must be clean and
dry.
24
2
5 3/8
4
24
3½"
3½"
Filler
¾"
Framed
cabinetry
['']
21
Advertisement
Table of Contents
