Baby Trend A La Mode Snap Gear HC38 E Series Instruction Manual page 9

OPERATION
• Wrap the back straps around the back of
the chair. Buckle the straps making sure
you hear the buckle *CLICK* closed
(Fig. 20c).
• Pull the free ends of the strap to firmly
tighten the Booster Seat to the chair
(Fig. 20d).
• Wrap bottom straps around the bottom of
the chair. Buckle the straps making sure
you hear buckle *CLICK* closed (Fig.
20e).
• Pull the free ends of the straps to firmly
tighten the Booster Seat onto the chair
(Fig. 20d).
• Check that the Booster is tightly installed
by attempting to move the Booster Seat
from side-to-side and up. The Booster
Seat should not move more than 1 inch.
TO REMOVE BOOSTER SEAT
FROM CHAIR
21) • Unbuckle the back and bottom straps
(Reference Step 20). Turn Booster Seat
over. Slide Strap Compartments open
on the bottom of the Booster Seat (Fig.
21a).
• Fold the straps and put them in
the compartment, then slide the
Compartment Door closed (Fig. 21b).
15
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO REATTACH SEAT PAD
22)
Fig. 20c
Fig. 20d
23)
Fig. 20e
TO REMOVE SEAT PAD
Reverse steps above.
Fig. 21a
Fig. 21b
• Thread non-buckle end of Harness
Straps called Harness Attachment
Tabs through the provided slots in the
Seat Fabric, Seat Back (Fig. 22a), and
Seat Base (Fig. 22b). When Harness
Attachment Tabs are through the
provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure
that the straps are firmly in place.
• Loop the flap on the back of the pad
over the top of the Seat Back (Fig. 23a).
Connect the Seat Pad to the Seat Back
with the two Elastic Loops. These fit
over the Attachment Tabs located near
the top harness slots (Fig. 23b).
• Insert the Harness Covers through the
Harness Straps (Fig. 23c).
Fig. 23a
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 22a
Fig. 22b
Fig. 23b Fig. 23c
16