Planning
Identify the type and height of your garage door. Survey your garage area to see if any of the conditions below apply to
your installation. Additional materials may be required. You may find it helpful to refer back to this page and the
accompanying illustrations as you proceed with the installation of your opener.
SECTIONAL DOOR INSTALLATION
Horizontal and vertical reinforcement
is needed for lightweight garage doors
(fiberglass, steel, aluminum,
door with glass panels, etc.).
See page 19 for details.
Safety Reversing Sensor
ONE-PIECE DOOR WITHOUT TRACK
Header
Wall
Gap between floor and bottom of
door must not exceed 1/4" (6 mm).
Safety
Reversing Sensor
Header Wall
Vertical Centerline
of Garage Door
Gap between floor and bottom of door
must not exceed 1/4" (6 mm).
Wall-
mounted
Door
Control
Safety
Reversing Sensor
FINISHED CEILING
Support bracket &
fastening hardware
is required.
See page 12.
Slack in chain tension
is normal when
garage door is closed.
Extension Spring
OR
Torsion Spring
Safety
Reversing
Sensor
ONE-PIECE DOOR WITH TRACK
Access
Door
4
Motor Unit
Wall-
mounted
Door
Control
Access Door
Motor Unit
Gap between floor
and bottom of door
Safety
must not exceed 1/4" (6 mm).
Reversing Sensor
Access
Door
Safety
Reversing Sensor