Samsung WF45R6100AP User Manual page 22

Installation
STEP 3 Adjust the leveling feet
STEP 4 Connect the water hose
22 English
1. Gently slide the washer into position.
Excessive force may damage the
leveling feet.
2. Using a wrench, turn the leveling feet
clockwise or counterclockwise to adjust
the height until the washer is level.
3. Using a flathead screwdriver, tighten
the locking nuts (A).
NOTE
An adjustable wrench or 17 mm open-end
wrench is required to adjust the leveling
feet.
CAUTION
• Make sure to use new water hoses and
that rubber gaskets (B) are inside the
couplings (A) at both ends of the hoses.
Water hoses without the gaskets may
leak.
• Allow 5 in. (127 mm) of space between
the back of the washer and the wall to
prevent water hoses from being kinked.
B
Kinked hoses may cause water leaks.
• If there is a water leak, stop using the
washer and contact a local Samsung
service center. A water leak may cause
A
electric shock.
• Do not stretch the water hoses by force.
If a hose is too short, replace the hose
with a longer hose.