Installation; Troubleshooting; Important Note - Wolf CW24/S Installation Manual

Cup warming drawer

Hide thumbs

Table Of Contents

Available languages

Installation

Preparation

Remove and recycle packing materials. Do not discard the

package containing two screws provided for installation.

If the cup warming drawer is installed independently, install

an anti-tip block against the rear cabinet wall. Verify the

screws are adequately secured and do not penetrate elec-

trical wiring or plumbing.

Installation

Turn off power to the electrical outlet.

Slide the left corner of the cup warming drawer into

the opening. If the electrical supply is located in the

opening, plug the power cord into the receptacle. If it

is located in an adjacent cabinet, guide the power cord

through the hole in the cabinet wall. Coil the excess

power cord behind or beside the unit.

Slide the unit back into the opening until the trim

meets the cabinet front. Avoid pinching the power cord

between the unit and cabinet wall.

Open the cup warming drawer to full extension. Drill a

pilot hole in each mounting hole, located at the front,

on each side of the unit. Refer to the illustration below.

Mount the unit using the two screws provided.

Turn power back on to the electrical outlet.

MOUNTING

HOLE

Mounting hole

Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &

Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.

All other trademarks are property of their respective owners in the United States and other countries.