LG RC7066A1F Owner's Manual page 11

Installation Procedure
1
Place the LG dryer on the LG washing
machine.
2
Remove the two screws from the bottom of the
rear cover on each side as illustrated below.
3
Align the stacking kit holes and the rear cover
holes.
• 3-1) 600 mm
• 3-1) 550 mm
4
Fasten the two screws that were removed
earlier from the dryer to the stacking kit.
5
Use the four screws in the accessory box (16
mm) to assemble the washing machine rear
cover and stacking kit.
6
The procedure for the opposite side will be the
same.
WARNING
• Incorrect installation can cause serious
accidents.
• The weight of the appliance and the height of
installation make the stacking procedure too
risky for one person. This procedure should
be performed by two or more qualified service
personnel.
• The appliance is not suitable for a built-in
installation. Please do not install as a built-in
appliance.
• Do not operate if the appliance is not properly
stacked.
EN
11