Selecting The Sound Mode - Samsung LE32C580J1K User Manual

Auto Volume (Off / Normal / Night)
To equalize the volume level on each channel, set to Normal.
Night : This mode provides an improved sound
■
experience compared to Normal mode, making almost
no noise. It is useful at night.
Speaker Select (External speaker / TV
speaker)
A sound echo may occur due to a difference in decoding
speed between the main speaker and the audio receiver. In
this case, set the TV to External Speaker.
✎
When Speaker Select is set to External Speaker, the
volume and buttons will not operate and the
MUTE
sound settings will be limited.
✎
When Speaker Select is set to External Speaker, you
should use these settings.
x
TV Speaker: Off , External Speaker: On
✎
When Speaker Select is set to TV Speaker, you
should use these settings.
x
TV Speaker: On , External Speaker: On
✎
If there is no video signal, both speakers will be mute.
Additional Setting
(digital channels only)
DTV Audio Level (MPEG / HE-AAC)
■
allows you to reduce the disparity of a voice signal
(which is one of the signals received during a digital TV
broadcast) to a desired level.
✎
According to the type of broadcast signal,
/ HE-AAC can be adjusted between -10dB and
0dB.
✎
To increase or decrease the volume, adjust
between the range 0 and -10 respectively.
: SPDIF (Sony Philips Digital InterFace)
SPDIF Output
■
is used to provide digital sound, reducing interference
going to speakers and various digital devices such as a
DVD player.
Audio Format: During the reception of a digital TV
broadcast, you can select the Digital Audio output
(SPDIF) format from the options PCM or Dolby Digital.
✎
By connecting to 5.1ch speakers in a Dolby
Digital setup, maximize your interactive 3D sound
experience.
Audio Delay: Correct audio-video mismatch, when
watching TV or video, and listening to digital audio
output using an external device such as an AV receiver.
Dolby Digital Comp (Line / RF)
■
signal disparity between a dolby digital signal and a
voice signal (i.e. MPEG Audio, HE-AAC, ATV Sound).
✎
Line: Set the output level for signals greater or less than
-31dB (reference) to either -20dB or -31dB.
RF: Set the output level for signals greater or less than
-20dB (reference) to either -10dB or -20dB.
Sound Reset (OK / Cancel)
Reset all sound settings to the factory defaults.
¦

Selecting the Sound Mode

When you set to Dual l-ll, the current
sound mode is displayed on the screen.
A2
: This function
Stereo
NICAM
MPEG
Stereo
✎
If the stereo signal is weak and an automatic switching,
occurs, then switch to the mono.
✎
Only activated in stereo sound signal.
✎
Only available when the
: This function minimizes
Select Line to obtain dynamic sound, and RF
to reduce the difference between loud and soft
sounds at night time.
Audio
Dual l-ll
Type
Mono Mono
Stereo ↔ mono
Stereo
Dual-I ↔ Dual-II
Dual
Mono Mono
Stereo Mono ↔ stereo
Mono → Dual-I
Dual
 Dual-II 
Input source is set to TV.
Default
Automatic
change
Dual-I
Automatic
change
Dual-I
17
English