Philips DVD960 Manual page 6

STANDARD CONNECTIONS
MULTICHANNEL SOUND FOR HOME THEATRE
AUDIO OUTPUT
VIDEO OUTPUT
DIG. OUT
Y/C Y U/Cr V/Cb CVBS A/V EUROCONNECTOR (RGB OUT) ANALOG COAX OPTO
For multichannel sound, your player provides both digital and
analog audio outputs.
DIGITAL (MPEG 2 MULTICHANNEL OR DOLBY
DIGITAL™) MULTICHANNEL SOUND
1 For this, which provides the highest multichannel sound
quality, you need a digital multichannel A/V receiver.
2 Connect the digital audio output on the rear of the player to
a suitable input on the receiver using a digital audio cable
(available as option). In this case, do not use the player's
audio Left and Right outputs.
3 You will need to activate the digital output of the player.
4 The audio format of the digital output is dependent on the
audio format of the selected audio stream. Make sure that
the selected audio stream matches the capabilities of the
receiver connected to the digital output.
ANALOG (DOLBY PRO LOGIC
1 If your TV set has a Dolby Pro Logic™ decoder, simply hook
up the player to the TV using the A/V Euroconnector, or
(optional) YUV, or Video (CVBS) and audio connections as
on precedent page.
2 If not, make the A/V Euroconnector, or (optional) YUV, or
Video (CVBS) connection to the TV, and connect the player's
audio Left and Right outputs to suitable inputs on a Dolby
Pro Logic™ Audio/Video receiver, using the cable supplied.
3 For speaker connections, follow the instructions given in
the TV set or A/V receiver user manual.
NOTE
- You cannot use the RF Modulator option for home theatre.
- If the audio format of the digital output does not match the
capabilities of your receiver, the sound will be muted.
english
10
DIGITAL AUDIO
IN
RECEIVER
DIGITAL AUDIO
CABLE
™ ) MULTICHANNEL SOUND
DIGITAL AUDIO (STEREO) SOUND
CONNECTION
For this connection, which produces the highest possible
stereo sound quality, you need an audio amplifier with digital
input, and the digital output of the player must be activated
(see Settings). Connect the player's digital audio output to the
corresponding input on the amplifier. In this case, do not use
the player's audio Left and Right outputs.
CONNECTING THE POWER SUPPLY
1 Plug the female end of the power cord supplied into the
Power connector on the rear of the player.
2 Plug the male end of the cord into an AC outlet.
NOTE
- When the player is in the "OFF" position, it still consumes
some power. If you wish to disconnect your player
completely from the power supply, withdraw the plug from
the AC Outlet.
CAUTION
Only qualified service personnel should remove the
cover or attempt to service this device.
INFRARED REMOTE CONTROL
LOADING THE BATTERIES
1 Open the battery compartment cover.
2 Insert three 'AA' (R6 or SUM3) batteries as indicated inside
the battery compartment.
3 Close the cover.
CAUTION
Do not mix old and new batteries. and NEVER mix
different types of batteries (standard, alkaline and so
on).