Trouble Shooting - Bosch BFL554MB0 Instruction Manual

Trouble shooting

en
Area Cleaning product
Appliance front Hot soapy water: Clean using a dish cloth and
then dry with a soft cloth. Do not use metal or
glass scrapers for cleaning.
Appliance front with Hot soapy water: Clean using a dish cloth and
stainless steel then dry with a soft cloth. Remove splashes
and patches of limescale, grease, starch and
albumin (e.g. egg white) immediately. Corro-
sion can form under these patches or
splashes. Special stainless-steel cleaning prod-
ucts are available from the after-sales service
or from specialist retailers. Do not use glass
cleaners or metal or glass scrapers for clean-
ing.
Cooking compart- Hot soapy water or vinegar solution: Clean
ment made of stain- using a dish cloth and then dry with a soft
less steel cloth.Do not use oven spray or any other
aggressive oven cleaners or abrasive materi-
als. Scouring pads, rough sponges and pan
cleaners are also unsuitable. These items
scratch the surface. Allow the interior surfaces
to dry completely.
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
If a dish does not turn out exactly as you wanted,
Tip:
refer to the following chapter, where you will find lots of
tips and notes relating to the optimum
settings.~ "Tested for you in our cooking studio"
on page 18
Fault table
Fault
The appliance is not working
Three zeros are lit on the display.
The appliance is not operating. A
cooking time is shown on the display.
The microwave is not working.
16
Possible cause
The plug is not plugged into the mains
Power failure
The circuit breaker/fuse is faulty
Faulty operation
Power failure
The rotary selector has been accidentally turned.
The "start" button has not been pressed after the set-
ting was applied.
The door has not been properly closed.
The "start" button has not been pressed.
Area Cleaning product
Recess in the cook- Damp cloth: Water must not be allowed to run
ing compartment into the appliance through the turntable drive.
Dry the turntable drive with a cloth.
Turntable and roller Hot soapy water: When placing the turntable
ring back into its recess, it must engage properly.
Wire rack Hot soapy water: Soak and clean with a dish
cloth or brush. Do not scour.Do not use metal
or glass scrapers for cleaning.
Door panels Glass cleaner: Clean with a dish cloth. Do not
use glass scrapers.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Remedy/information
Connect the appliance to the electricity supply
Check whether other kitchen appliances are working
Check in the fuse box to make sure that the circuit
breaker/fuse for the appliance is in working order
Switch off the circuit breaker/fuse for the appliance in
the fuse box and switch it back on after approximately
10 seconds
Reset the time.
Press the "stop" button.
Press the "start" button or cancel the setting by press-
ing the "stop" button.
Check whether food remnants or debris is/are
trapped in the door.
Press the "start" button.