Output Section - YORKVILLE POWER MAX YS1011 Owner's Manual

Phantom
Phones
On
B
Circuit
Breaker

Output Section

34. Headphones Level Control and Output Jack
The level control regulates the output of the headphone amplifier. The headphone output
jack is located on the front of the mixer beside the Phantom Power switch. The head-
phone program originates from the main L/R buss unless a solo is active in which case it
originates from the Solo bus.
35. Amplifier AMP A, B, C and D Inputs
Each Amplifier Input uses a switching jack that cuts off internal signals routed to the
power amp when a jack is Inserted.
The Amplifier Inputs have a few possible uses. For example, they enable you to access,
and isolate the main power built-in amps so that they may be used in conjunction with
an electronic crossover (used to bi-amp subwoofers and full-range speakers.) In this case
you would patch as follows,
i. PowerMAX L/Mono Line Level Output to the crossover's input (if it is a stereo cross-
over, pick one channel and use its input).
ii. From the crossover's low frequency, or subwoofer output to the PowerMAX Amp A
Input.
iii. From the crossover's high frequency output to Amp B Input.
iv. Now, connect the subwoofers to the Amp A Speaker output/s and the full-range cabi-
nets to the Amp B Speaker output/s.
Two 8 ohm full-range speakers, and two 8 ohm subwoofers can be powered this way.
Actually, if you have a 3-way crossover or processor and only need one monitor power
amp, you can tri-amp by using Amp A for subs, Amp B for woofers and Amp D for horns
and/or tweeters.
Alternately, the Amplifier Inputs can be used to slave one or more of the power amps
– perhaps if the mixer is connected to a rack of amps and now the built-in amps are
free to be used for other things. In another case, you might be using the PowerMAX
L&R Line Level Outputs, also Mon 1 and 2, patched into four of another mixer's input
channels. Now you may want to amplify the full mix coming out of that other board
including whatever it's doing (possibly you're jamming with another group and you
need extra channels). You would simply patch its main and monitor outputs into the
appropriate Amplifier Inputs and now the two mixers are linked and the PowerMAX
amps are ready to power up main and monitor speakers.
36. Amplifier Full Power LEDs
The Amplifier Full-Power LEDs are located in the upper right
panel area just above the main EQ. They indicate that one or
more power amp limiters (all non-defeatable) are working.
Limiting begins 10 dB down from the onset of clipping and
tends to be sonically transparent unless these LEDs are work-
ing constantly. If an LED is lit continuously, it indicates that
you have run out of limiter room on that amplifier and are
approaching the point where the mixer will begin to clip.
SPEAKER Outputs
Mon 2
Mon 1
D C A
A-Z1162 / 1v0
S T A T U S
Power Amplifier Full-Power Phantom
A B C D
Mon 1 Mon 2
13