Installation; Technical Features; Installation Instructions - Smeg FMI120S1 Instruction Manual

5.1. Technical Features

AC voltage
Fuse
Power required
Grill power
Microwave output
power
Microwave frequency
Outer dimensions
(WHD)
Cavity dimensions
(WHD)
Oven capacity
Weight

5.2. Installation Instructions

Use the "open" button to open the door and
remove all packaging materials. Then clean the
inside and the accessories with a damp cloth and
dry them. Do not use abrasive or strong-smelling
products.
Ensure that the following parts are in good
condition:

Door and hinges

Front of the microwave

Inner and outer surfaces of the appliance
DO NOT USE THE APPLIANCE if you notice any
kind of defect in the aforementioned parts. If this
occurs, contact the After Sales Service.
Place the appliance on a stable, flat surface.
Fit the rotating base in the centre of the microwave
cavity and place the rotating plate on top until it
clicks into position. Whenever the microwave is
used, both the rotating plate and the respective
base must be inside the oven and correctly
positioned. The rotating plate turns clockwise and
anti-clockwise.
Warning! The microwave oven may be wrapped
in a protective film. Before switching it on for the
first time, carefully remove this film, starting at the
underside.

Installation

(See characteristics
plate)
8 A / 250 V
1200 W
1000 W
850 W
2450 MHz
595  390  340 mm
305  210  305 mm
18 l
18.6 kg
smeg-tr.com
In order to ensure proper ventilation for the
appliance, install the frame in the correct way.
Please refer to the following pictures:
Warning: after installing the microwave, it is
necessary to guarantee access to the electrical
socket.
During installation, ensure that the power
cable does not come into contact with the back
of the appliance,
temperatures may damage the cable.
If you are installing a microwave and a
conventional oven in the same column, the
microwave must not be placed under the oven,
because of the formation of condensation.
The electrical installation is to be set up so that the
appliance can be isolated from the mains with a
minimum 3mm all-pole contact separation.
Suitable separation devices include e.g. cutouts,
fuses (screw fuses are to be taken out of the
holder), RCD's and contactors. This installation
must comply with current regulations.
If the electrical connection is done through a plug
and this remains accessible after installation, then
it is not necessary to provide the mentioned
separation device.
Protection against electric shock must be provided
by the electrical installation
Warning: The oven must be earthed.
The appliance must not be placed in the vicinity of
heating elements, radios or television sets.
In case of fault, the manufacturer and the seller
will not accept any responsibility if the installation
instructions have not been properly followed.
because the high
25 / EN