Electrolux ERG19610 User Manual page 21

Problem
The lamp does not
work.
The Pilot light flash-
es.
The compressor op-
erates continually.
The compressor
does not start im-
mediately after
pressing the Action
Cool button, or after
changing the tem-
perature.
Water flows on the
rear plate of the re-
frigerator.
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
Possible cause
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The appliance is not work-
ing properly.
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
The compressor starts af-
ter a period of time.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
Schnellkühlen function
switched on.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Contact a qualified electri-
cian.
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
This is correct.
This is correct.
Switch off Schnellkühlen
Action Coolmanually, or
wait to set the temperature
until the function has reset
automatically. Refer to " Ac-
tion Cool function".
Set a higher/lower tempera-
ture.
21