Basic Operations - Kenwood TK-7302 Instruction Manual

S p
witching ower
Press to switch the transceiver ON.
• A beep sounds and the display illuminates.
• If the Transceiver Password function is programmed, "PS" will appear on the display
when the power is turned ON. Refer to "Transceiver Password", below.
Press again to switch the transceiver OFF.
n Transceiver Password
To enter the password:
1 Press /
• When using a keypad, simply enter the password digits and proceed to step 3.
2 Press C> to accept the entered digit and move to the next digit.
• Press A or # to delete an incorrect digit. Press and hold A or # to delete all
digits.
• Repeat steps  and 2 to enter the entire password.
3 Press S or
• If you enter an incorrect password, the transceiver remains locked.
A
djuSting the
Press the Volume Up key to increase the volume. Press the Volume Down key
to decrease the volume.
If Squelch Off has been programmed onto a key, you can use that function to
listen to background noise while adjusting the volume level.
S Z
electing A one And
Select the desired zone and channel using the keys programmed as Zone Up/
Zone Down and Channel Up/ Channel Down.
• "G" (Zone ) appears on the display.
t / r
rAnSmitting
1 Select your desired zone and channel.
• In Voting and Voting with Signaling zones, the channel is selected automatically.
2 Press microphone PTT switch and speak into the microphone to transmit.
Release the PTT switch to receive.
• For best sound quality at the receiving station, hold the microphone approximately
.5 inches (3 ~ 4 cm) from your mouth.

BASIC OPERATIONS

on/ oFF
to select a digit.
to confirm the password.
V
olume
c
hAnnel
eceiVing
5