Asko DFI663 Operating Instructions Manual page 18

Problem
Water remains in the dishwasher above the
filters.
Bad odor in dishwasher.
The dishes are not dry enough.
18
Possible causes
The filters are blocked.
The filters are not fitted correctly.
Debris in the drain pump.
Drain pump stop missing.
Kink in drain hose.
Blocked drain hose.
Dirt around the seals and in corners.
Low temperature programs have been selected
for a prolonged period.
The dishwasher is connected to a garbage
disposer.
Depending on the load, the program's drying
cycle may be insufficient.
The dishwasher is not fully loaded.
Rinse aid needs topping up or dosage is set too
low.
Action
Clean the coarse and fine filters.
Check that the filter handle is locked in the stop
position. The handle should point straight out
from the dishwasher.
Clean the drain pump. See the chapter Care
and maintenance instructions.
Check that the colored stop on the right in the
bottom drain is in place. See the chapter Care
and maintenance instructions.
Check that the hose is free from kinks and sharp
bends.
Loosen the drain hose from where it terminates.
Check that no debris has clogged the hose. Is
the cone-shaped part of the drain boot cut to
the maximum size of the fitting where it
attaches?
Clean with dish brush and low foaming cleaner.
Run a program with a higher temperature once
or twice a month. Or run a self-cleaning
program. See Self-cleaning in the chapter Using
the dishwasher.
Cleaning the garbage disposer connected to
the dishwasher can eliminate odors. Follow the
disposer manufacturer's cleaning instructions.
Activate the Extra Dry option.
Fully load the dishwasher.
Top up with rinse aid or increase the rinse aid
dosage level. See the chapter Settings.
Open the door a little once the program has
finished.