Table of Contents
Advertisement
OPERATION
Dim/Dark Mode
Dim/Dark Mode reduces the illumination of the display.
• P ress and hold
(Power) for 2 seconds to reduce illumi-
nation to a Dim setting. Display re a d s :
• P ressing and holding
for 2 seconds a second time
engages Dark Mode. Display re a d s :
Dim or dark can be engaged during an alert. In Dark Mode,
the display goes dark for as long as a signal is being detect-
ed and for 20 seconds after, then the display re t u rns to the
dimmer setting.
• P ressing and holding
a third time re s t o res full illumina-
tion to the display.
Engaging/Disengaging VG-2
See Option Select Mode to turn this feature on.
14
OPERATION
Stay Alert Feature
The Stay Alert Feature is designed to test a driver's aler t-
ness. To engage (when unit is not alarming):
• P ress and hold City for approximately 2 seconds.
Release the button during or immediately after the alert is
given. Display reads:
Within 30-60 seconds two beeps are sounded; to show alert-
ness, the driver must press either the
(Quiet) button within 3-5 seconds. If the button is pre s s e d
within 3-5 seconds, the cycle is re p e a t e d .
If a button was not pressed within 3-5 seconds alarm sounds
and the display re a d s :
• Press
(Power) to exit.
WA R N I N G ! ! ! Stay Alert is NOT intended as a substitute for
adequate rest. You should NOT operate a vehicle if you are
d ro w s y. During extended periods of vehicle operation, you
should take frequent breaks. Improper reliance on the Stay
A l e rt feature may result in vehicle damage, personal injury or
d e a t h . NEVER OPERATE A VEHICLE IF YOU ARE DROWSY.
15
(Volume), City or
Advertisement
Table of Contents
