Fig. 18: Fitting The Turbocharger 2; Table 5: Fitting The Turbocharger, Value X, L - ABB HT602839 Operation Manual

Operation Manual / A150-M56/66/57/67 - A155-M..
3 Removing and Installing / 3.3 Installing the turbocharger
Fig. 18: Fitting the turbocharger 2
Product
A150
A155
Table 5: Fitting the turbocharger, value X, L
Step C – Aligning the turbocharger on the bracket
1. Lightly lubricate the hole, into which the centering bush (42193) is inserted, with screw
grease.
2. Position threaded rod with centering bush in the bracket.
3. Insert centering bush into bracket until the stop is reached.
4. Carefully lower turbocharger onto bracket and position using the centering bushes
(42193) located in the bracket.
5. Check value x.
If value x is not reached, the turbocharger must be lifted up from the bracket and re-
u
aligned.
Step D – Fixing the threaded rod in place in the bracket
Using the hexagon, screw the threaded rod into the bracket up to value L.
u
If value L is not reached or the threaded rod jams while being screwed in, the threaded
u
rod must be loosened by no more than ½ revolution (this will loosen the centering bush
which may have jammed the rod). Then continue screwing in the threaded rod.
If value L is not reached, undo the screw connection, carefully take the turbocharger off
u
the bracket and repeat the procedure starting with Step A.
Observe the instructions for fastening the turbocharger with clamping nuts (see chapter
u
Fastening the turbocharger with a clamping nut
© Copyright 2021 ABB. All rights reserved.
Value X
112 ±2 mm
144 ±2 mm
HZTL4032_EN
Value L
52 ±2 mm
72 ±2 mm
→36).
Rev.Q January 2021