GE 17 Owner's Manual And Installation Instructions page 12

INSTALLING THE WATER LINE
1
CONNECT THE TUBING
7
TO THE REFRIGERATOR
NOTES:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
• We recommend installing a water filter if your water
supply has sand or particles that could clog the screen
of the refrigerator's water valve. Install it in the water
line near the refrigerator. If using GE SmartConnect
Refrigerator Tubing kit, you will need an additional
tube (WX08X10002) to connect the filter. Do not cut
plastic tube to install filter.
Remove the access cover.
Remove the plastic flexible
cap from the water valve
(refrigerator connection).
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown. On GE
SmartConnect Refrigerator Tubing kit,
™
the nuts are already assembled to the tubing.
Insert the end of the tubing into the water valve
connection as far as possible. While holding the
tubing, tighten the fitting.
For plastic tubing from a GE SmartConnect
Refrigerator Tubing kit, insert the molded end
of the tubing into the shutoff valve and tighten
compression nut until it is hand tight, then
tighten one additional turn with a wrench.
Overtightening may cause leaks.
Fasten the tubing into the clamp provided
to hold it in a vertical position. You may need
to pry open the clamp.
1/4" Copper
Tubing
Refrigerator Connection
Reattach the access cover.
Installation Instructions
™
™
Tubing Clamp
1/4" Compression
Nut
Ferrule (sleeve)
SmartConnect
™
Tubing
12
(CONT.)
TURN THE WATER
8
ON AT THE
SHUTOFF VALVE
Tighten any connections
that leak.
PLUG IN THE REFRIGERATOR
9
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
START THE ICEMAKER
10
On power switch models, set the icemaker power
switch to the 0N position. On feeler arm models,
move the feeler arm to the ON (down) position. The
icemaker will not begin to operate until it reaches its
operating temperature of 15°F (–9°C) or below.
It will then begin operation automatically.
Power
switch
Feeler arm model
NOTE: In lower water pressure conditions, the water
valve may turn on up to 3 times to deliver enough
water to the icemaker.
OFF
ON
Power switch model
Feeler Arm in the
STOP (up) position
Feeler Arm in
the ON (down) position