Related Manuals for Blomberg DWS 51502 SS
Summary of Contents for Blomberg DWS 51502 SS
- Page 1 Dishwasher Installation Manual DWS 51500 SS DWS 51500 FBI DWS 51502 SS DWS 51502 FBI...
- Page 2 Dishwasher Installation Manual DWS 51500 SS DWS 51500 FBI DWS 51502 SS DWS 51502 FBI...
-
Page 3: Table Of Contents
To prevent accidents, which could cause serious injury or death, as well as machine damage read these instructions before installation and / or use. INTRODUCTION 1. IMPORTANT SAFETY INSTRUCTIONS 1.1 INSPECT THE DISHWASHER 2. TOOLS WHICH MAY BE NEEDED 3. MATERIALS WHICH MAY BE NEEDED 4. -
Page 4: Introduction
INTRODUCTION WARNING Please read this installation manual When installing the dishwasher, follow and particularly the safety instructions basic precautions, including the completely and carefully. They will save you following: time and effort and help to ensure optimum • The dishwasher could only be converted dishwasher performance. -
Page 5: Inspect The Dishwasher
1.1 INSPECT THE DISHWASHER designed for an electrical supply of 120 V (volts), 60 Hz (hertz), AC, connected to a After unpacking the dishwasher and prior dishwasher-dedicated, properly grounded to installation, thoroughly inspect the electrical circuit with a fuse or breakers dishwasher for possible freight or cosmetic rated for 15 amperes. -
Page 6: Tools Which May Be Needed
2. TOOLS WHICH MAY BE NEEDED 3. MATERIALS WHICH MAY BE NEEDED (Additional materials may be required to comply with local codes) Hot Water Supply Line - Minimum 3/8” O.D. copper tubing or metal braided dishwasher supply line. Elbow with 3/4” N.P.T. female thread for dishwasher side, and sized to fit your water supply line (copper tubing/compression fitting, or braided hose) on the other side. -
Page 7: Materials Supplied
4. MATERIALS SUPPLIED 4.1 PARTS SUPPLIED 4.4 DISHWASHER PARTS BAG 2 Parts for your dishwasher will come in several plastic bags. (MODEL DEPENDING) Check your parts bags shown In addition to the manual bag to make sure you have all the and the dishwasher parts bag parts as listed to the left. -
Page 8: Dishwasher Specifications
5. DISHWASHER SPECIFICATIONS 5.1 TECHNICAL FEATURES Permissible water pressure 4.35 - 145 psi (0.3 - 10 bars) Electrical connection 120 V (volts), 12 A (amps), 60Hz (hertz) Total power 1400 W (watts) Heater power 1100 W (watts) NOTICE : Because we continually strive to improve our products, we may change our specifications and design without prior notice. -
Page 9: Enclosure Preparation
6. ENCLOSURE PREPARATION 6.1 ELECTRICAL PREPARATION WARNING The dishwasher is designed for an electrical supply of 120 V, 60 Hz, AC, connected to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker rated for 15 amperes. 6.2 PREPARATION FOR INSTALLING MOUNTING BRACKETS WARNING Dishwasher must be secured to adjacent cabinetry using the mounting brackets provided. - Page 10 (+50mm)
-
Page 11: Adjusting Height
Place the two mounting brackets into the top corners of the dishwasher. Fix the mounting brackets (A) to the top corners of the dishwasher, with the screws supplied. Bend sides of mounting brackets (B) in order to fix from sides (if necessary). 6.3 ADJUSTING HEIGHT If the height of the enclosure is 337/8”... -
Page 12: Installing The Side Trim Strips
6.4 INSTALLING THE SIDE TRIM STRIPS Remove the adhesive tape (Figure A). Place the trim strips on the front edge of the side walls (Figure B). NOTICE : • Make sure you use the correct trim strip since there is a left and right side strip. The flexible material should be facing forward (Figure B). -
Page 13: Drain Preparation
If the dishwasher is installed in a location that experiences freezing temperatures (e.g. in a vacation home, cabin etc.), you must drain all the water from the dishwasher’s interior. Water system ruptures that occur as a result of freezing are not covered by warranty. -
Page 14: Steam Protection Foil
6.7 STEAM PROTECTION FOIL Steam will form inside the dishwasher during operation. At the end of the cycle, when the dishwasher door is opened, it is required to use a steam protection foil to prevent any steam from collecting on the underside of the counter top. 6.6.2 FITTING THE PROTECTION FOIL Before applying the steam protection foil to the underside of the countertop, clean the area with... -
Page 15: Placement Of Dishwasher Into The Opening
7. PLACEMENT OF DISHWASHER INTO THE OPENING Now place the dishwasher into the opening and get ready to connect all hoses and electrical connections. CAUTION Make sure all hoses are pulled through the side opening of the cabinet, no hoses are kinked and all slack is taken out as shown in the above figure. - Page 16 7.1.2 WATER SUPPLY CONNECTION • The access hole of the supply cord to the Water supply may be connected to the installation compartment must be smooth dishwasher in one of two ways: and rounded and it must be large enough •...
-
Page 17: Readjusting Foot Levels
7.2 READJUSTING FOOT LEVELS Now that the dishwasher is in the cabinet you must readjust the feet to bring the dishwasher up to the required height and attach it underneath the countertop. 1. Readjust the front foot levels with adjusting wrench to balance the dishwasher and raise it up under the countertop, make sure the unit is level. - Page 18 Lock the toe kick brackets as shown with the plastic tab in the figure C by pushing the plastic tab on the dishwasher into the teeth of the bracket ( 3. Now attach the toe kick to the bracket with the two (Ø...
-
Page 19: Fixing The Cabinet To The Counter
7.4 FIXING THE CABINET TO THE COUNTER... -
Page 20: Preparing The Timber Door
7.5 PREPARING THE TIMBER DOOR Mid. Point Mid. Point Weight (max) 5.5 Kg 12,1 lb Height (h) : Height of the wooden door 28” (720mm) Width : 17 ½” to 17 ¾” (442 mm - 448 mm) Thickness : ¾ “ (19mm) Weight (max) : 5,5 Kg / 12,1 lbs... -
Page 21: Preparing The Product Door
7.6 PREPARING THE PRODUCT DOOR... -
Page 22: Installing The Timber Door
7.7 INSTALLING THE TIMBER DOOR 7.8 FIXING THE TIMBER DOOR... -
Page 23: Fixing The Timber Door
7.9 FIXING THE TIMBER DOOR Ø 4 x 43mm 7.10 ADJUSTING THE KICK PLATE • Check whether the bottom of the door hits the toe kick of the kitchen cabinet (A). • If the door hits the toe kick cut the necessary section out of the toe kick (B). - Page 24 NOTICE : If you have a European kitchen or want to install a wooden toe kick to match your kitchen, please refer to one of the two drawings given below. Follow the same instructions on the brackets as for the removable toe kick.
-
Page 25: Connection
7.11 CONNECTION ~ 1500 ~ 1800 ~ 2000... -
Page 26: Installer Checklist
8. INSTALLER CHECKLIST Notice : Your installer must have completed and • If your dishwasher is not operating checked the following: properly after following these steps: • The dishwasher is square and level. Contact your dealer to schedule an • The dishwasher is fastened securely to authorized service agent to inspect your the cabinetry. - Page 27 www.blomberginternational.com info@blomberginternational.com...