Attaching The Protective Tube - Panasonic SF4D-A18 Instruction Manual

Mounting
When using as a safety device for a press machine or paper shearing machine in Japan

2-4-4 Attaching the protective tube

When using as a safety device for a press machine or paper shearing machine in Japan, always
attach the protective tube SFPD-A10 (option) to the cable.
Step 1 Cut a length of the protective tube equal to the length of the cable to be used.
Note: Cut a length of the protective tube that is sufficient to cover the entire cable (excluding the connectors).
A protective tube is not needed for the bottom cap cable SFD-CCB□ or SFD-CB□, nor for the direct con-
nection cable SFD-CSL□, nor for the section of the cable (about 33mm) that overlaps with the device when
connected to the device.
Step 2 Separate the protective tube as shown below.
Step 3 Insert the cable.
Step 4 Reinsert the protective tube to restore to its original state.
48
Protective tube
About
33mm
© Panasonic Industrial Devices SUNX Co., Ltd. 2020