Table of Contents
Advertisement
R Make sure that the wall and the fixing method are strong enough to support the
weight of the unit.
Battery installation/Battery charging
Important:
R Use the supplied rechargeable batteries. For replacement, we recommend using
the Panasonic rechargeable batteries noted on page 2.
R USE ONLY rechargeable Ni-MH batteries AAA (R03) size (
R Do NOT use alkaline/manganese/Ni-Cd batteries.
R Confirm correct polarities (
Charge for about 7 hours.
R Confirm "Charging" is displayed (
R When the batteries are fully charged, "Fully charged" is displayed.
Note:
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
charge again.
Registering a handset to a base unit
1
Base unit:
Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop,
2
Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
Note:
R If an error tone sounds, or if
the base unit's operating instructions.
For assistance, please visit http://shop.panasonic.com/support
TGFA30US(en)_0210_ver102.pdf 3
,
then repeat this step.
is displayed.
,
).
2
).
1
) and the charge contacts with a dry cloth and
is displayed, register the handset according to
Installation
1
).
2
3
2017/02/10 19:12:03
Advertisement
Table of Contents
